If you are having problems printing badges with a usb printer (the model number is QL-710W or QL-800), walk through the troubleshooting steps below



Kiosk Not Printing Badges:

  1. Ensure that the kiosk is plugged into power.

  2. Ensure that the printer is plugged into power.

  3. Ensure that the printer is on and that the ‘status’ light is green.  No other light should be on.

  4. Ensure that the printer’s USB cord is plugged in FULLY to the printer.

  5. Ensure that the printer has badge tape and is installed properly

    1. Take out the badge tape roll and re-insert it inside the guide slot
    2. Feed the badge tape through the front of printer 
    3. Close the badge tape door 
    4. Pressing the feed and cut buttons
  6. If all of this is correct, unplug the printer power cord from the printer and wait 4-5 seconds

    1. Plug the printer back in and make sure that the status light is green.

    2. A pop-up screen will appear saying ‘Unfortunately, Accushield has stopped’.

    3. Tap ‘OK’.  The kiosk will sync.

    4. The ‘Sign In/Sign Out’ screen will appear after the system reboots.



Printer Status Light is Red or Flashing Red/Orange:

  1. Check to make sure that the printer has paper installed.

  2. Check to make sure that the printer paper has not jammed.

  3. Check to make sure that the printer paper is fully and properly fed through the front by pressing the feed button and confirming smooth operation.



"Error Connect Socket Failed" Kiosk Error Message:

  1. For the Brother QL-800 printer, make sure that the Editor Lite mode is disabled

  2. If the Editor Lite lamp is lit, press and hold down the Editor Lite button until the Editor Lite lamp turns off



If you still can not print, please send us an email at techsupport@accushield.com or call us at 1-800-478-5085 and select option 2 for communities, option 1 for existing communities, and then option 1 for kiosk support.